IBM 8649 - Eserver xSeries 225, Maintenance And Troubleshooting Manual

Page: 124 / 194

Service processor error codes
When viewed from POST, Remote Supervisor Adapter error codes will appear in
hexadecimal form (generally beginning with A2, A3, A4, A5, A6, A7, AD, AE, or E1).
However, when viewed from the System Error Log, the messages will appear as
text. To determine a possible error condition for the service processor, see the
System Error Log (see “Viewing error logs from diagnostic programs” on page 22).
SCSI error codes
Error code FRU/action
All SCSI Errors One or more of the
following might be causing the problem:
v A failing SCSI device
(adapter, drive, controller)
v
An improper SCSI configuration or SCSI
termination jumper setting
v Duplicate SCSI IDs in the same SCSI
chain
v
A missing or improperly installed SCSI
terminator
v
A defective SCSI terminator
v
An improperly installed cable
v
A defective cable
1. External SCSI devices must be turned on before you turn on the
server.
2. Make sure that the cables for all external SCSI devices are
connected correctly.
3. If you have attached an external SCSI device to the server, make
sure the external SCSI termination is set to automatic.
4. Make sure that the last device in each SCSI chain is terminated
correctly.
5. Make sure that the SCSI devices are configured correctly.
Temperature error messages
Note: See “System replaceable units” on page 122 to determine which components should be replaced by a field
service technician.
Message Action
DASD Over Temperature
(level-critical; direct access storage device
bay x was over temperature)
Ensure that the system is being properly cooled; see “System reliability
considerations” on page 33
DASD Over recommended Temperature
(sensor x )
(level-warning; DASD bay x had over
temperature condition)
Ensure that the system is being properly cooled; see “System reliability
considerations” on page 33
DASD under recommended temperature
(sensor x ) (level-warning; direct access
storage device bay x had under
temperature condition)
Ambient temperature must be within normal operating specifications;
see “Features and specifications” on page 3
DASD Over Temperature
(level-critical; sensor for DASD1 reported
temperature over recommended range)
Ensure that the system is being properly cooled; see “System reliability
considerations” on page 33
Power supply x Temperature Fault
(level-critical; power supply x had over
temperature condition)
1. Ensure system is being properly cooled; see “System reliability
considerations” on page 33
2. Replace power supply x
System board is over recommended
temperature
(level-warning; system board is over
recommended temperature)
1. Ensure system is being properly cooled; see “System reliability
considerations” on page 33
2. Replace the system board.
114
IBM xSeries 225 Types 8649: Hardware Maintenance Manual and Troubleshooting Guide