IBM 8480 - Eserver xSeries 205, Maintenance And Troubleshooting Manual

Page: 82 / 174

5. Free the processor from the system board by rotating the processor socket
lever arm upward to its maximum vertical position.
6. Lift the processor up and out of the computer.
7. To install a processor, reverse the previous steps.
Note: When reconnecting the fan sink cable to the system board, be sure to
connect the cable to the connector marked
″
CPU fan
″
.
Hot-swap hard disk drive cage
Note:
v
Read “Safety information” on page 119.
v Read “System reliability considerations” on page 33.
Note: The illustration above may differ slightly from your server.
To remove the hot-swap hard disk drive, complete the following steps:
1. Turn off the server, if it is on.
2. Unplug the server.
3. Remove the front bezel. See “Removing the front bezel” on page 68.
4. Remove the side cover. See “Removing the side cover” on page 40.
5. Remove the support-bracket assembly. See “Removing the side cover” on page
40.
6. Remove any hard disk drives or drive fillers from the drives.
7. Disconnect the hard disk drive cables that connect to the system board.
8. Remove the screws from the front of the hard disk drive cage.
9. Move the cage slightly in and up until it is free of the chassis and lift it out of the
server.
Note: Take care not to dislodge the memory when you remove the cage.
72
IBM xSeries 205 Type 8480: Hardware Maintenance Manual and Troubleshooting Guide