IBM 8480 - Eserver xSeries 205, Maintenance And Troubleshooting Manual, Page: 100 / 174

Diagnostic error codes
Note: In the following error codes, if XXX is 000 , 195 , or 197 , do not replace a
FRU. The description for these error codes are:
000 The test passed.
195 The Esc key was pressed to stop the test.
197 Warning; a hardware failure might not have occurred.
For all error codes, replace the FRU or take the action indicated.
Note: See “System” on page 112 to determine which components should be replaced by a field service technician.
Error code/symptom FRU/action
001-XXX-000
(Failed core tests)
v
System board.
001-XXX-001
(Failed core tests)
v System board.
001-250-000
(Failed system board ECC)
v
System board.
001-250-001
(Failed system board ECC)
v
System board.
005-XXX-000
(Failed video test)
v Extender card.
011-XXX-000
(Failed COM1 serial port test)
v
System board.
011-XXX-001
(Failed COM2 serial port test)
v System board.
014-XXX-000
(Failed parallel port test)
v
System board.
015-XXX-001
(USB interface not found, board damaged)
v System board.
015-XXX-015
(Failed USB external loopback test.)
1. Make sure the parallel port is not disabled.
2. Run the USB external loopback test again.
3. System board.
015-XXX-198
(USB device connected during USB test.)
1. Remove USB devices from USB1 and USB2.
2. Run the USB external loopback test again.
3. System board.
020-XXX-000
(Failed PCI interface test.)
v System board.
020-XXX-001
(Failed hot-swap slot 1 PCI latch test.)
1. PCI hot-swap latch assembly
2. System board.
020-XXX-002
(Failed Hot-swap slot 2 PCI latch test.)
1. PCI hot-swap latch assembly.
2. System board.
020-XXX-003
(Failed hot-swap slot 3 PCI latch test.)
1. PCI hot-swap latch assembly.
2. System board.
020-XXX-004
(Failed hot-swap slot 4 PCI latch test.)
1. PCI hot-swap latch assembly.
2. System board.
90
IBM xSeries 205 Type 8480: Hardware Maintenance Manual and Troubleshooting Guide