IBM 7331, Installation Manual

Page: 43 / 62

Chapter 3. Moving the 8mm Tape Library
This chapter describes how to pack and move the 8mm Tape Library Model 3xx.
Move Checklist
Attention: Damage as a result of improper handling may void your equipment
warranty. Consult your local Service Representative to obtain packing materials or
assistance in preparing your Tape Library for moving.
Please do all of the following steps when moving the stand-alone Tape Library.
Note: You may need to contact a person who is knowledgeable in system
management, planning, configuration, or operations to complete some of
these steps.
Step 1. If not already done, do a controlled shutdown of the system unit.
CAUTION:
Do not place a highly reflective surface between either the picker
assembly and the tape cartridge magazines or between the
picker assembly and the tape drives. This may cause damage to
your eyes. (RSFTC238)
Step 2. Remove any tape cartridges loaded in the tape drives.
Step 3. Power-off the library. Refer to the 7331 and 3449 8mm Tape Library
Model 3xx Operator Guide, GA32-0376, for instructions on powering
off the library.
Copyright IBM Corp. 1997
25