IBM 7331, Installation Manual, Page: 30 / 62

Step 8. Position bezel and filler strip assembly
3
on rack and fasten in place
with 2 screws
1
(typical 4 places) on each side. Screws are inserted
from inside the rack through rack upright into pan nuts in bezel strips
2
. See Figure 9.
Figure 9. Filler Strip and Bezel Strip Installation
Step 9. Slide the base plate until aligned with the bezel and filler strip
assembly.
Step 10. Refer back to Figure 7 on page 10 for this procedure. At the rear of
the base plate
2
, align holes through base plate with threaded hole
in rails on each side
1
and
3
.
Step 11. Refer back to Figure 7 on page 10 for this procedure. Insert screws
4
through the holes aligned in previous step into the threaded hole
in the rail and tighten screws to secure the base plate in place.
Step 12. Obtain the library to be installed.
Step 13. Open the library front door
4
. See Figure 10 on page 13.
Step 14. Remove the cable tie securing the control panel cable
2
to the safety
cover
3
.
Step 15. Disconnect the control panel signal cable from the control panel.
DANGER
To prevent a possible electrical shock when adding or
removing any devices to or from the system, ensure that
the power cords for those devices are unplugged before
the signal cables are connected or disconnected. If
possible, disconnect all power cords from the existing
system before you add or remove a device.
12
7331 and 3449 Installation Guide