IBM 7331, Installation Manual, Page: 33 / 62

Step 26. Connect each frame-to-door ground strap to the inside of the front
door. See Figure 10 on page 13.
Step 27. Connect the control panel signal cable to the control panel.
Step 28. Install a cable tie to secure the control panel cable to the safety cover.
Note: The door does not lock in step 29. The library door solenoid
locks the door when library power is turned On.
Step 29. Close the library front door. Ensure the door latches and operates
correctly.
Step 30. Ensure the library, filler panel, and bezel assembly are all correctly
aligned.
Step 31. If two libraries are installed in the rack, connect the rear upper inside
corners of the library frames with an alignment strap.
Step 32. Connect the external SCSI cables between the host computer system
and the 8mm Tape Library. See “Step 8. Connecting the SCSI Signal
Cable” on page 16.
Step 33. Plug the library power cable into the rack power outlet.
Step 34. Install any rack panels that were removed fro the library installation.
Step 35. Go to “Step 13. 8mm Tape Library Checkout Procedure” on page 20.
Chapter 2. 8mm Tape Library Installation
15