2.1.7 Step 7. Connecting the SCSI Bus Cable
To connect the SCSI bus cable, do the following:
__ 1. On the rear of the 7208 Tape Drive, insert the device connector end of the SCSI bus cable into one of the connectors. See Figure
4.
__ 2. Push in until the cable is seated.
__ 3. Tighten the two thumbscrews (finger tight).
+------------------------------------------------------------------------+
¦ ¦
¦ ¦
¦ ¦
¦ PICTURE 8 ¦
¦ ¦
¦ ¦
+------------------------------------------------------------------------+
Figure 4. Connecting the SCSI Bus Cable to the 7208 Tape Drive
__ 4. Connect the other end of the SCSI bus cable as follows:
If the 7208 Tape Drive is the only device attached to the system, connect the cable to the system unit (see Figure 5 in topic 2.1.8).
If the 7208 Tape Drive is part of a multiple-device configuration, connect the SCSI cable to the next device (see Figure 6 in topic
2.1.8).
7208 Model 341 Setup and Operator Guide
Step 7. Connecting the SCSI Bus Cable
¦ Copyright IBM Corp. 1997
2.1.7 - 1
