IBM 628791U - PC 300 GL, User Manual

Page: 117 / 176

POST
Message Description
1882 A Plug and Play adapter has requested an I/O address that is
not available, or the Plug and Play adapter might be defective.
Action:
1. Make sure that all ISA legacy adapters are set correctly in
the Configuration/Setup Utility Program. If the I/O address
settings are not correct, change and save the settings. Setting
the resources used by ISA legacy adapters to ISA Resource
enables the Plug and Play function to configure around the
legacy adapters.
For background information on PCI, ISA, Plug and Play, and
legacy adapters, see “Working with Adapters” on page 68.
For information about required I/O resource settings for ISA
legacy adapters, see the documentation supplied with these
adapters. For more information, see Chapter 5, “Using the
Configuration/Setup Utility Program” on page 29.
2. Make sure that switches on all ISA legacy adapters are set
correctly. For information about switch settings, see the
documentation supplied with the ISA legacy adapters.
3. If all I/O addresses are being used by ISA legacy adapters,
you might need to remove an ISA legacy adapter to make an
I/O address available to the Plug and Play adapter you want
to install. For instructions on removing adapters, see
“Working with Adapters” on page 68.
Note: If you remove an ISA legacy adapter, set the I/O
address used by the removed adapter to Available
before installing another adapter.
4. If you have other PCI or Plug and Play adapters installed,
you might need to remove one of these adapters to make an
I/O address available to the Plug and Play adapter you want
to install.
If the problem cannot be corrected, have the computer serviced.
Chapter 8. Troubleshooting
103