IBM 622138U - IntelliStation Z - Pro 6221, User Manual

Page: 91 / 142

Table 4. POST error messages (continued)
POST message Description
1762 Hard disk configuration error.
Action: Take the following steps to correct the problem:
1. Make sure that the hard disk drive is set correctly in the Configuration/Setup Utility
program.
2. Make sure that the hard disk drive cables are correctly and securely connected.
3. If the problem remains, replace the hard disk drive.
If the problem remains, call for service.
1800 A PCI adapter has requested a hardware interrupt that is not available.
Action: Take the following steps to correct the problem:
1. Make sure that the PCI adapter and all other adapters are set correctly in the
Configuration/Setup Utility program. If the interrupt resource settings are not correct,
change the settings.
2. If all interrupts are being used by other adapters, you might need to remove an adapter to
make an interrupt available to the PCI adapter, or force other adapters to share an
interrupt.
1962 No valid startup devices were found. The system cannot find the startup drive or operating
system.
Action: Be sure that the drive you want to start from is in the startup sequence.
1. Select Start Options from the Configuration/Setup Utility program main menu. If you are
unable to set the startup sequence, call for service.
2. Check the list of startup devices in the Startup device data fields. Is the drive you want to
start from in the startup sequence?
Yes Exit from this screen; then, select Exit Setup to exit the Configuration/Setup
menu. Go to step 3.
No Follow the instructions on the screen to add the drive; then, save the changes and
exit the Configuration/Setup menu. Restart the computer.
3. Is an operating system installed?
Yes Turn off the computer. Go to step 4.
No Install the operating system in your computer; then, follow your operating system
instructions to shut down and restart the computer.
4. During computer startup, watch for messages indicating a hardware problem.
If the same error message appears, call for service.
2400 An error occurred during the testing of the video controller on the system board. This error can
be caused by a failing system board or a failing video adapter (if one is installed).
Action: Call for service.
2462 A video memory configuration error occurred.
Action: Call for service.
5962 An IDE CD-ROM configuration error occurred.
Action: Check the signal and power cable connections to the CD-ROM drive.
If the problem remains, call for service.
Chapter 5. Solving problems
69