IBM 4mm DDS-2 Tape Autoloader, Installation And User Manual

Page: 40 / 52

SemiLoaded A cartridge is in the drive, but not loaded.
Unloading Either the drive is unloading a cartridge, or a semiloaded cartridge is
being ejected and moved back to its slot in the magazine.
Write x.y The drive is writing data to tape. "x.y":1 is the cumulative
compression ratio since the power was turned on, or since the
compression ratio was last cleared. For example, "Write 2.1" means
a compression ratio of 2.1:1. The compression ratio will be displayed
after a 1MB of data has been written since the power was turned on.
Information Messages:
The following information messages can be displayed:
Config: xxy "xx" is the hexadecimal value of the Configuration switches situated
on the underside of the Autoloader; "y" is the hexadecimal value of
the switches on the rear of the Autoloader.
Eject Mag The Eject button has been pressed.
Force Eject A forced ejection is in progress, (refer to “Forcing an Ejection” on
page 5-5). It remains until the magazine is ejected.
Load Tape The Load Tape button has been pressed.
SCSI ID: x "x" is the Autoloader's SCSI address.
Select Tape Displayed when the Select button is pressed, and for a short time
afterwards.
Stray Tape: Insert Empty Mag A cartridge is in the drive mechanism, although no
magazine is inserted. Insert an empty magazine to retrieve the
cartridge.
5-12
4mm DDS-2 Tape Autoloader Installation and User's Guide