IBM 4820, System Reference Manual

Page: 100 / 124

Note: To route cables through the counter, drill two 7/8 inch holes through the
counter. Trim the remaining material between the holes with a small saw or
chisel.
2. Place the pedestal so that the receiving bolts align with the counter screw holes.
3. Use the enclosed M6 screws to secure the pedestal to the counter as shown in
Figure A-1 on page A-1. The slots located in the metal support bracket allow you to
position the pedestal for maximum stability.
Attaching the free-standing pedestal to the counter
Follow these steps to mount the 4820 SurePoint Solution to your counter.
1. Using the template (see Figure C-2 on page C-2) as a guide, mark the screw hole
locations for drilling through the counter. Use 8 mm bit, or 5/16 inch bit to drill the
four screw holes.
2. Place the pedestal so that the mounting bolts align with the counter screw holes.
3. Use the enclosed M6 screws to secure the pedestal to the counter. The slots
located in the metal support bracket allow you to position the pedestal for maximum
stability.
4. Continue with your installation.
Mounting the pedestal
A-2
4820 SurePoint Solution System Reference