IBM 326m - eServer - 7969, Hardware Maintenance Manual, Page: 18 / 172

If an optional Remote Supervisor Adapter II (system-management adapter) is
installed in PCI-X slot 1, the server has additional connectors and LEDs. See the
documentation that comes with the adapter for more information about these
connectors and LEDs.
Server power features
When the server is connected to an ac power source but is not turned on, the
operating system does not run, and all core logic except for the service processor
(also called the baseboard management controller) is shut down; however, the
server can respond to requests from the service processor, such as a remote
request to turn on the server. The power-on LED flashes to indicate that the server
is connected to ac power but not turned on.
Turning on the server
Approximately 20 seconds after the server is connected to ac power, the
power-control button becomes active, and one or more fans might start running to
provide cooling while the server is connected to power. You can turn on the server
and start the operating system by pressing the power-control button.
The server can also be turned on in any of the following ways:
v
If a power failure occurs while the server is turned on, the server will restart
automatically when power is restored.
v If an optional Remote Supervisor Adapter II is installed in the server, the server
can be turned on from the Remote Supervisor Adapter II user interface.
v
If your operating system supports the Wake on LAN feature, the Wake on LAN
feature can turn on the server.
8
326m Type 7969: Hardware Maintenance Manual and Troubleshooting Guide