IBM 300 Series 6268, Hardware Maintenance Manual

Page: 165 / 450

Ÿ
PCI Wake Up: The computer can be automatically
powered on from any PCI device that will generate a
Wake Up event.
Ÿ
Wake on LAN: If the computer has a properly
configured token-ring or Ethernet LAN adapter card
that is Wake on LAN-enabled and there is remote
network management software, you can use the
IBM-developed Wake on LAN feature. When you set
Wake on LAN to Enabled, the computer will turn on
when it receives a specific signal from another
computer on the local area network (LAN). For
further information, see “Wake on LAN” on page 156.
Network settings
This section applies only to computers linked to a network.
The Configuration/Setup Utility program includes settings
that can be enabled and disabled to configure the network
interface in the computer. These settings are:
Ÿ
Flash over LAN (Update POST/BIOS over Network)
Ÿ
Wake on LAN
Flash over LAN (update POST/BIOS
over network)
Note: For local Flash (BIOS/VPD) update, see “Flash
(BIOS/VPD) update procedure” on page 152.
This setting is used to enable or disable the Flash over
LAN feature. When the feature is enabled, the system
programs, in the computer, can be updated remotely from
a network server. If the administrator password is set in
the computer, it does not have to be entered by the server.
To access the Flash over LAN setting:
1. Start the Configuration/Setup Utility program. See
“Setup Utility program” on page 139.
2. Select System Security.
3. Select Remote Administration from the
Configuration/Setup Utility program menu.
4. To enable Flash over LAN, select Enabled. To
disable Flash over LAN, select Disabled.
5. Press Esc twice to return to the Configuration/Setup
Utility program menu.
6. Before you exit from the program, select Save
Settings from the Configuration/Setup Utility program
menu.
7. To exit from the Configuration/Setup Utility program,
press Esc and follow the instructions on the screen.
PC 300 - 6563/6564/6574 Aptiva - 2178/2198
155