5
2.1
Loosen (but do not remove) the four rail adjustment screws on each rail.
Right rail
Left rail
Front of rack
Rear of rack
Rail adjustment
screws
2.2
Use the figure on the next page for reference. At the front of the rack,
position the right-hand rail into the rack at the appropriate EIA location.
Make sure that the two locating pins seat properly in holes H3 and H4.
The bottom of the rail should line up with the bottom EIA boundary.
When installed, each N3300 will occupy a 2U space.
Using one silver pan head M5 screw, attach the
rail to the
front of the rack using hole H6. T
Note:
right-hand
ighten this screw with a screwdriver.
2.3
At the rear of the rack, position the
rail at the same EIA
location used in step 2.2. Make sure that the locating pins seat properly
in holes H3 and H4. Using two silver pan head M5 screws,
Tighten these screws with a
screwdriver.
right-hand
attach the rail
to the rack using holes H2 and H5.
2.4
Tighten the four rail adjustment screws on the installed rail.
Locating pins
