8.6
8.8
Check the licenses on the node(s) by entering the following command:
Add any missing licenses by entering the following command for each
missing license:
where
is the license code for the product.
Clustering must be licensed on both nodes in a dual-node N3300.
license
license add
xxxx
xxxx
Note:
Reboot the node(s) by entering the following command:
Reboot
Initial setup is now complete for a single-node N3300. Refer to the
to verify that the system is set up correctly and
ready to operate. Give all documentation (including this document) and
all hardware to the customer.
To complete the initial setup of a dual-node N3300, continue with Step
8.9.
IBM
System Storage N series Data ONTAP Software Setup Guide
for your
version of Data ONTAP
8.9
8.10
Enable clustering by entering the following command on one node's
console:
cf enable
Check each node's status by entering the following command:
cf status
Initial setup is now complete for a dual-node N3300. Refer to the
to verify that the system is set up correctly
and ready to operate. Give all documentation (including this document)
and all hardware to the customer.
IBM
System Storage N series Data Active-Active Configuration Guide
for
your version of Data ONTAP
19
8.7
Continue with post-setup configuration as needed.