IBM 2145-4F2, Installation Manual

Page: 53 / 143

8
fibre-channel port 1
The following figure shows an illustration of the type of connector located on the
power supply assembly. The connector allows you to connect the SAN Volume
Controller 2145-4F2 to the power source from the uninterruptible power supply.
Preparing your SAN Volume Controller environment
Before installing the SAN Volume Controller, you must prepare the physical
environment.
Preparing your SAN Volume Controller 2145-8F2 or SAN Volume
Controller 2145-8F4 environment
The following four tables list the physical dimensions and weight of the node, as
well as other environmental requirements that you must consider before you install
your SAN Volume Controller 2145-8F2 or SAN Volume Controller 2145-8F4:
Dimensions and weight
Height Width Depth Maximum weight
43 mm
(1.69 in.)
440 mm
(17.32 in.)
686 mm
(27 in.)
12.7 kg
(28 lb)
Additional space requirements
Location
Additional space
requirements Reason
Left and right sides 50 mm
(2 in.)
Cooling air flow
Back Minimum:
100 mm (4 in.)
Cable exit
AC input-voltage requirements
Power supply
assembly type Voltage Frequency
200 to 240 V 88 to 264 V ac 50 or 60 Hz
Ground
Live
Neutral
Chapter 1. SAN Volume Controller overview
23