Operating Instructions
Adaptor
Please select the plug that fits your mains outlet.
1.
Laser output aperture: Never
point the laser beam to
people. Never look directly
into the laser beam.
2.
LED light panel: 6x RGB LED’s,
60° scatter angle
3.
IR signal receiver: point the
remote control to this
receiver
4.
MODE switch: Press to cycle
through the 4 operating
modes: Auto fast, auto slow,
sound controlled and sound
controlled strobe.
5.
Microphone: Receives the
sound signal. Adjust the sensitivity by pressing the MUSIC button on the remote control for 2 seconds. Then
you can set the sensitivity via the number buttons from 1-30. 30 is the highest sensitivity, 1 is the lowest.
Default setting is 18.
6.
LPC: Adjustment of the green laser power. Turn clockwise to increase the power.
7.
Hole for hanging bracket: Allows the installation and angle adjustment of the unit
8.
Adapter socket: Plug the 12Vdc plug of the adaptor into this socket.
Remote control
Remove the insulating tip from the batteries
Operation of the remote control
ON/OFF switch
: press to switch the unit ON and OFF. Keep
pressed for 4 seconds to enter into STANDBY mode. Press again
to wake the unit up.
AUTO mode
: press to enter into auto mode. Press again to
toggle between AUTO FAST and AUTO SMOOTH. The number
keys are deactivated during auto mode.
MUSIC
: Press to enter into SOUND CONTROLLED mode. Press
again to toggle between MUSIC & MUSIC STROBE mode
MUSIC mode
: Red & green light up to the rhythm of the music
MUSIC STROBE
: The red and green laser react as a strobe to the sound of
the music; Set the sensitivity/speed via the number keys 0-9 and the +-
key. The adjustment range is 1-30. 1 is slowest, 30 is highest. Press the
number key 9 to set the sensitivity to 9. If you want to set the sensitivity
e.g. to 26, press the key +- and then press 2 and 6.
COLOR SELECTION MODE
:
LASER
: Red, green, red+green
LED
: Red, green, blue, red+green, red+blue, green+blue,
red+green+blue
©Copyright Lotronic 2014
LAS360RG-FIREFLY
4
