© 2002 IBICO
Operations Manual
Page 6-2
Patriot 12HR, 25HC, 38HC
4.
Move the lower idler out of the locked position.
5.
Pull the lower roll of laminating film around the lower
idler and back towards the front of the laminator. Pull
enough film to allow it to drape over the roll.
6.
Pull the upper laminating film down over the upper
idler and drape over the heat rollers.
7.
If using film not pre-aligned on the supply shaft, align
edges of the upper and lower rolls of laminating film with
the center of the heat rollers. Secure the rolls of laminating
film in place by tightening the thumb screws located on
the core adapters.
INFORMATION: If using standard rolls of film, use
the pre-aligned holes on the supply shaft.
8.
Slide the feed table under the draped film from the
lower supply roll and replace the feed table ensuring the
film stays on top of the feed table. Lower the safety shield
into the fully closed position.
9.
Slide the threading card ( a piece of heavy stock paper,
card board or similar product) between the feed table
and the film resting on the feed table. Push the threading
card into the nip of the heat rollers.
