26
Create
Modify
Delete
Run
The right side of the Select Program Screen
The right half of the display holds all the controls for creating, editing and manipulating the user
programs. Located at the far right are the door control buttons for raising and lowering the platform.
Located immediately below the door arrows is the
Cancel
button. Touching this button will bring you
back to the MAIN SCREEN.
Note!
Touching a
Cancel
or
OK
button on any screen will bring you back to the previous screen. The
OK
button may update or save any applicable changes whereas the
Cancel
button will not.
Create new programs by touching this button. You can create a program only in an
empty memory location. A memory location is considered empty if the area to the
right of the program number is blank. In Example Display #19, the only empty
memory location is slot #009. All other memory locations have a name to the right
of the program number and are, therefore, not empty.
For example, in Example Display #19, if you select program # 12 and then touch the
CREATE button, an error message will be displayed. You must then press the OK
button to clear the alarm. You must either Delete or Move the program from slot
#12 before you can create a new program there.
NOTE!
For pressing furnaces, you will be prompted to choose whether you are
creating a porcelain program or a pressing program.
NOTE!
The operating system does not check for duplicate program names.
Therefore, different memory locations can have the same program name.
This button is used to bring up the Edit screen where all editing functions to an
existing program can be performed.
NOTE!
A program must be created and saved prior to its being edited.
This button is used to delete an existing program. Deleting a program will make its
memory location blank again. A new program can now be created in this memory
location. There is no way to recover a deleted program unless it was saved to a
memory stick where it can be imported along with all the other programs on the
memory stick.
This button starts the selected user program.
NOTE!
The platform must be fully lowered prior to running a program. If the
platform is not fully lowered and the
“RUN”
button is touched, an alarm will sound,
the platform will start to lower and a warning message, “Wait until door opens
then press
RUN
” will be displayed. You must touch the
OK
button to silence the
alarm and clear the warning message. Once the door has reached the lower limit
and stops, the
RUN
button can again be touched.
Summary of Contents for SUMMIT
Page 10: ...10 Photo 3 ...