iBell IBL SG60-26, Operator'S Manual, Page: 15 / 16

14
Suspected malfunctions are often due to causes that the users can
fix themselves, therefore check the product using this section.
Problem Possible Cause Solution
1. Little or no
material flow
1.1 Nozzle, Suction
tube or Air filter
clogged.
1.2 Low flow rate.
1.3 No pressure
build up in paint
tank or loosed
suction tube.
1.1 Inspect and Clean
these, Replace if
necessary.
1.2 Increase flow rate.
1.3 Tighten these parts.
2. Material
leaking
2.1 Loose or worn
Nozzle.
2.2
Material build up
on air cap and
nozzle.
2.1 Tighten or Replace.
2.2 Clean the material.
3.
Spray pattern
too thick
3.1 Material flow
setting too high.
3.2 Nozzle or air
filter clogged.
3.1 Adjust material flow
setting to low.
3.2 Clean it, if required
replace it.
4. Spray jet
pulsates
4.1 Container material
running out.
4.2 Air filter clogged. 4.1 Refill the material.
4.2 Change the filter.
TROUBLESHOOTING
WARNING!
All further inspection and repair work must be
performed by an authorised service centre or a qualified technician!
NOTE:
This product does not contain any parts that can be repaired
by the consumer. Contact an authorised service centre or a similarly
qualified person to have it checked and repaired.
IBL SG60-26