14
WARNING!
Do not use the product if it is damaged or shows wear.
Switch the product off immediately if you are disturbed while
working by other people entering the working area.
Always use sharp bits. Dull or damaged bits may cause undue stress
and possibly break, causing injury.
Refer specific instructions on page no. 6 before operation
.
Plug the power cord into a suitable outlet. Slide the direction
trigger to determine the rotation direction of the chuck.
Secure the work piece to keep it from moving during the
operation. Use a punch to mark the position of the hole.
Pre-drill the holes with a smaller diameter of the screw to be
screwed. Hold the tool perpendicular to the screw to be screwed
in or out. Holding it at an angle may cause slipping or jamming of
the driver bit.
Place the tip of the driver bit directly on the screw first and then
switch the product ON.
You can lock the trigger in the ON position for continuous
operation by the trigger, pressing in the lock ON button, and
releasing the trigger.
The trigger has a variable speed feature. Pressing it lightly will
make the tool operate slowly, pressing more will cause the tool to
operate faster.
Only apply as much pressure as necessary to keep the screw in
place and the driver bit in contact with the screw head. Too much
pressure will cause damage to the screw head and driver bit, too
little pressure will cause the driver bit to slide away.
Use the tool only for light drilling, with this same procedure, by
changing the torque setting to drill mode.
Remove blocked and stuck screws by changing the rotational
direction. After use, switch the tool OFF and let it cool down.
GENERAL OPERATION
IBL SD 10-86|12-75
