18
Wiring for a Marine Application
When installed in a marine application using the
DC power cable, the YELLOW wire can be wired
to a suitable panel switch which will allow the
IsatDock LITE to be turned off when not in use.
Optional ISD951 AC Plug Pack Installation
For installation with the optional ISD951
110-240 AC plug pack connect the 4-way
Microfit connector from the plug pack to the
4-way power connector on the rear cable loom
of the IsatDock LITE. In this configuration the
ignition/accessory status is always ON.
cradle by applying pressure to the top of the
handset. An audible ‘click’ is heard when the
phone is in the docked position.
4.
To remove the handset from the cradle,
press the EJECT button at the top of the
docking station. The dock will swing out
and the handset can be removed.
IsatDock LITE Usage
Docking & undocking the IsatPhone
Pro handset
To place the IsatPhone Pro into the docking unit, both
the ‘covers’ on the external antenna connectors and
the USB/Audio connectors need to be opened.
1.
The antenna ‘cover’ must be placed at 90
degrees to the antenna connector cavity and
run parallel to the top edge of the phone.
2.
The ‘cover’ in the base of the phone should be
at a 90 degrees fully opened position.
3.
To dock the handset, align the IsatPhone Pro
with the phone tray and slide the handset
down until it seats flush to the bottom of the
tray. Swing the phone down into the
Eject Button
1
2
Summary of Contents for IsatDock LITE
Page 1: ...IsatDock LITE User Manual ...
