IBC Water AS0922TC-CL, Installation & Operating Instructions Manual

Page: 4 / 46

AS0922TC-CL Page
4
FITTED WITH MODEL WS1 VALVE and TC CONTROL
Check the equipment upon arrival for damage or shortages and report same to our Office or Agent before
starting.
Position the Softener on a firm foundation, preferably concrete, with sufficient space for operation and
maintenance. The softener must be within One and a Half metres of a 240V-10 amp Power Outlet. The
softener
MUST be installed under cover and protected from the weather as the Valve control and Transformer
are not waterproof.
STEP 1
The Softener is supplied with the resin preloaded in the tank and the valve/ bypass assembled
on the tank.
STEP 2 Connect the Inlet and Outlet pipes and Drain line to the control valve as per the instruction
book installation details.
Note the directional arrows on the Valve. The inlet is on the right
hand side facing the front of the valve . The drain is from the larger elbow on the top of the
valve. The valve Inlet and Outlet threads are 25mm BSP Female with a 12mm push on Hose
connection for the drain line.
STEP 3 Remove front lid from the cabinet. Then connect cabinet brine overflow drain line to waste
trap.
STEP4 Load Two bags of 25kg high purity water softener salt into the cabinet and replace front lid.
IBC Water recommends that only high purity salt be used in the softener .
STEP5
Refer to Instruction booklet for start up procedure (placing conditioner into Service") and it is
recommended to read fully the instruction manual before commencing the installation and
placing the system into operation.
Table 3
MODEL RESIN LITRES CABINET - SALT
LOADING KG
AS0922TC-CL 22 50
BASIC INSTALLATION
OF
IBC CABINET WATER SOFTENER SYSTEM