INSTALLATIONS
8
IB905 User’s Manual
Installing the Memory
The IB905 board supports one DDR3 memory socket for a maximum
total memory of 4GB in DDR3 SO-DIMM memory type.
Installing and Removing Memory Modules
To install the DDR3 modules, locate the memory slot on the board and
perform the following steps:
1.
Hold the DDR3 module so that the key of the DDR3 module aligns
with that on the memory slot. Insert the module into the socket at a
slight angle (approximately 30 degrees). Note that the socket and
module are both keyed, which means that the module can be installed
only in one direction.
2.
To seat the memory module into the socket, apply firm and even
pressure to each end of the module until you feel it slip down into the
socket.
3.
With the module properly seated in the socket, rotate the module
downward. Continue pressing downward until the clips at each end
lock into position.
4.
To remove the DDR3 module, press the clips with both hands.
Summary of Contents for IB905
