iBall Baton DWA-N150 Series, Manual

Page: 24 / 84

21
The following table describes the parameters of this page:
Field Description
WAN Physical Type
You can select ADSL WAN or Ethernet
WAN .
Default Route Selection You can select Auto or Specified .
VPI
The virtual path between two points in an
ATM network, ranging from 0 to 255.
VCI
The virtual channel between two points in an
ATM network, ranging from 32 to 65535 (1 to
31 are reserved for known protocols)
Encapsulation You can choose LLC and VC-Mux .
Channel Mode
You can choose 1483 Bridged , 1483 MER ,
PPPoE , PPPoA , 1483 Routed or IPoA .
Enable NAPT
Select it to enable Network Address Port
Translation (NAPT) function. When it is
unselected, to access the Internet normally,
you must add a route on the uplink
equipment. Otherwise, the access to the
Internet will fail. Usually it is enabled.
Enable IGMP
You can enable or disable Internet Group
Management Protocol (IGMP) function.
PPP Settings
User Name
For PPP dial-up, enter the user name
provided by your ISP.
Password
For PPP dial-up, enter the password provided
by your ISP.
Type
You can choose Continuous , Connect on
Demand , or Manual .
Idle Time (min)
If Connect on Demand is set, you need to
enter the idle timeout time. Within the preset
minutes, if the router does not detect the flow
of the user continuously, it will automatically
disconnect the PPPoE connection.
WAN IP Settings
Type You can choose Fixed IP or DHCP .