The specifications are subject to change without notice. 13 of 16
English
Model: GT700 Version: 1.0
Pressing and holding the power button for about 3 seconds to turn on the GT700 and it will
start to link to GSM system signal for about 60 seconds. The GSM LED (red) flash fast first
and then flash slow each for several times depend on GSM received state, please waiting for
the SYS LED (blue) lighted after. The GT700 will read all data of SIM card about few seconds
then the SYS LED (blue) die out until done. The GT700 is searching GPS signal when the
GPS LED (red) start to flash. The GT700 will search position date for about 5 minutes then to
locate the first position, when located the GPS LED (red) lighted for about 20 sec, it will die
out and that is GT700 enter the saving mode for about 518 sec. It is a circle that GT700 will
automatically awaken and search for GPS signal for about 1’30” or after located 20 seconds
then it will enter the saving mode.
10. Function perform
(1)
Basic Calling Features
i. To call out
：
Pressing one of the T1, T2 or T3 buttons, when the SYS LED (blue) turns
on then it can be dialed.
ii. To receive calls
：
Pressing the green button, when the SYS LED (blue) turns on then it
can be received.
iii. To hang up
：
Pressing the red button, when the SYS LED (blue) turns on then it can be
hung up.
iv. To adjust the speaker volume
：
Pressing the side buttons ‘
＋
’ or ‘
－
’.
v. To Set up the incoming call alert
Press and hold the volume ‘+’ button on the side of the GT700, at the same time:
a. Press the T1 button for ring alert mode.
b. Press the T2 button for vibration mode.
c. Press the T3 button for both ring alert and vibration modes.
(2)
To Send an Emergency Message
The user presses and holds the ‘SOS’ button (for about 5 seconds) until the SYS LED
(blue) turns on then release it, and the GT700 will transmit the positional information to
