IAC INDUSTRIES 930, Assembly Instructions Manual

Page: 4 / 8

4
Parts List: 930 Hand Crank Adjustable Bench
(Ref. Figure 1) Hardware Kit
– HWR461*
Item Description Qty. Item Description Qty.
1 Worksurface 1 E Screw, 10-32x 3.00L PHP 3 *
2 930 Leg Sub-Assy-Rt & Lt 1ea F Washer, # 10 Flat Zinc 3 *
3 Front Support Beam 1.5H 1 G Nut, #10-32 Hex Keps 3 *
4 930 Modesty Panel 1 H Cap, 2.00” x 3.00” 10-14 Ga 4*
5 930/940 Stiffener Beam 1 J Floor Glide 5/16-18 x 1.75 x 1.625Dia 4*
A Hex Head Bolt 1/4-20x.75 26 * K Bracket, 950/950-QS Hand Crank 1.50H 1*
B Washer, 1/4 Flat 34* L Screw, #6 x .500 PPH SMS Zinc 4*
C Nut, 1/4-20 Hex Keps 8* M Cable Tie, Mount Plastic (#6) 4*
D Bolt, 1/4-20 x .75 SQ. Head GR2 6 * N Cable Tie, #8 4*
1/4-20x .75 1/4-20 1/4-20x .75 1/4-20 10-32x 3.00L # 10 #10-32
HH Bolt Flat washer SQ.H Bolt Hex Keps Nut PHP Screw Flat washer Hex Keps Nut
CAUTION: Do not operate hand crank cylinders without the weight of the worksurface
on the frame. To do so may cause a vacuum in the lines and possible damage to the
system. Be cautious to hold the leg assemblies together when turning workbench
over after assembly making sure they do not separate.
Reference Assembly Drawing Above
(This will require no less than two persons)
1. Place worksurface (item 1) on clean surface underside facing up.
2. Loosely install the front beam (items 3) and leg assemblies (item #2) to the worksurface
using 1/4-20x.75 hex head bolts (item A) and 1/4
flat washers (item B).
Note : Before installing leg assemblies (item #2) to the worksurface attach pedestal end
caps (item H) and floor glides (item J) at this time.
3. Loosely attach the front beam (items 3) to the leg assemblies (item #2) using 1/4-20x.75
hex head bolts (item A), 1/4
flat washers (item B) and 1/4 hex keps nuts (item C).
4. Install part of the modesty panel (item 5) hardware
1/4-20 x .75 SQ. Head GR2 Bolt (item D)
to each leg assemblies (item 2) by sliding the head of
the three bolts (item D) on each pedestal upper channel
as shown.