INSTALLATION
• Trigger an Alarm When Ethernet is Lost: set an alarm condition
when Ethernet disconnected.
• Digital Input: send a signal to the camera to trigger an alarm. Check
it to enable this function. Then, set digital input as “High” or “Low”
• Motion Detection: this function is designed to record video once the
camera detects a motion condition. Select “Disable” to disable this
function or “Enable” to enable this function.
Please note this is for future use.
• Sensibility: set sensibility level as “Lowest”, “Low”, “Medium”,
“High” or “Highest”. Or input a value from 0 to 99 in the customized
threshold field. Higher number gets higher sensitivity.
• Press “Save” to save your settings.
• Action: Configure image transfer settings after triggering an alarm.
- Digital Output: select “OFF” to disable this function or “ON”
to enable this function. If select “ON”, choose an output file’s
resolution as “Low” or “High”.
- Digital Output - If you want to set digital output function start, you
need to set ON. After that, you need to set “Active Type” (Low or
High) about digital output by the hardware.
• Alarm duration - The alarm time period of digital output.
26
