Installation
①
Remove the Touch USB Dongle from the Transmitter.
②
Insert the Dongle into the USB In port of your laptop or PC.
③
Connect the Transmitter to the HDMI out port of laptop or PC. Use the HDMI extension cable
provided if needed.
④
Slide the power switch to the left to turn power ON and the Status LED will be lit in blue.
⑤
Press the Transmit button and an image will appear on the display device of which the Receiver
is installed.
- If multiple Transmitters are connected, the corresponding screen of the Transmitter that has
just been clicked will appear, as part of the product
’s integrated switching function.
For first use: please find the instructions to pair transmitter with receiver in the User
Manual of the Receiver, or on www.i3-learning.com
➎
➍
➊
➋
➌
General description of the device
A set of i3SYNC Touch Transmitter
(HDMI Dongle)
will be inserted to both HDMI sink and source
device. The purpose of this transmitter is to send the video and audio data to slave device wirelessly.
The i3SYNC Touch USB
(USB Dongle)
will enable the touch panel function on the sink device.
To do so, a set of i3SYNC Touch USB will be inserted to both HDMI sink and source device. And
they will coordinate the command on the touch panel of the slave device and Master device.
*Note: The USB Dongle(i3SYNC Touch USB Dongle) is the transmitter and it does not transmit any data when
It is attached on i3SYNC Touch TX. Before use, take the USB Dongle out of the transmitter and put it in the desired USB slot on the
source(and sink) device for transmitting coordination data.
