I-Tork PDS Pneumatic Actuator
Installation and operating manual (PDS-M0108/1010)
I-TORK PDS PNEUMATIC ACTUATOR
11
11
11
11
8.
Dismantle and Assembly
(
For Replacing O-ring and other parts
.)
PD series (Double Acting)
Dismantling
Caution: Vent all compressed air from the actuator and disconnect all electric
power before dismantling.
1)
Loosen the adjusting screws (23).
2)
Loosen both end cover bolts (26) using Hexagonal Wrench and dismantle.
3)
Using the spanner, rotate the stem more than 90°
until pistons are released
automatically and pull out the pistons (3).
4)
Loosen the Set Screw (27) of Scotch - Yoke (5).
5)
Take the Snap Ring (21)/Washer (12)/Thrust Washer (11) out from the top of
shaft.
6)
Separate the shaft (4) from the body.
7)
Replace the part.
8)
For Assembly: Do the Reverse.
PS series (Single Acting)
Dismantling
Caution: Vent all compressed air from the actuator and disconnect all electric
power before dismantling.
1)
Loosen the adjusting screws (23).
2)
Using hexagonal wrench, loosen 2 bolts (26) in a diagonal position on both end
covers.
Then loosen the other 2 bolts in a diagonal position on both end covers slowly.
(
Ensure spring pack pressure is released before removing bolts fully, if unsure,
then remove 2 diagonal bolts only and insert longer bolts until spring pressure is
released
)
3)
Take out the cover (28) and spring pack (22/29/30/31/32/33).
4)
Using the spanner, rotate the stem more than 90°
until pistons are released
