< Part 4 >
< 4.1 > QD Connection
rP
DC 12V In
4=>
Camera 1
P Camera 2
Camera 3
Camera 4
VCR(DVR)
0 ^ VCR
Monitor
Processor
1.
VCR i n :
This BNC connector is connected to video output from VCR/DVR. A pre-recorded quad screen signal from a tape can be
played back through a VCR/DVR and displayed on the video output channels. Push the VCR button (#2) to switch the
device to VCR Playback mode.
2.
VCR o u t :
This BNC connector is to be connected to the Video in from your VCR/DVR. It will only provide a quad screen video to
ensure an un-interrupted video recording for all four cameras. The display video is not affected by the control panel.
3. Terminations
:
These impedance switches are used to provide proper termination for each camera input. These switches toggle be
tween 75Q and Hi-Z impedance. Incorrect termination will degrade the quality of the video signal. All video inputs not
"looped through" to another device, the corresponding switches need to be set to 75D termination position. If another
device is connected to video out loop through connector set the corresponding termination switch to Hi-Z position. Any
device connected to the video out loop through connectors needs to be configure to 75Q video termination. The factory
default termination setting is 7 5 0 .
4. C M In, Ch2 In, Ch3 In, and Ch4 In
Video
IN
connectors
:
These BNC connectors are used to connect to the video out from camera. Four cameras can be connected to these con
nectors to form a quad screen in the following mapping order.
1
2
3
4
J
5. Ch1 Out, Ch2 Out, Ch3 Out, and Ch4 Out Video Loop through connectors
:
These connectors are used to loop video signals from each camera out to other devices.
P.8
