background image

 

MNPG127-02 

Pag. 6 

 

! WARNINGS! 

-

 

The perfect functionality of the device is guaranteed in accordance with the 
rules  of  installation  and  of  use  included,  only  with  original  accessories  and 
spare parts.  

-

 

If there are problems or installation difficulties, please contact the I.A.C.E.R. 
srl technical assistance department.  

-

 

The  correct  position  while  moving  the  machine:  the  apparatus  has  to  be 
moved  exclusively  by  gripping  it  with  both  hands  on  the  curved  profiles  of 
the lid. 

-

 

If you want to install an extern interlock circuit, contact exclusively qualified 
technicians and supply them the scheme correspondent to the room used for 
the  emission  of  the  treatment.  A  bad  installation  of  the  device  can  to 
generate serious ocular lesions.  

-

 

Before  connecting  the  cable  to  the  mains  plug,  check  that  the  equipment 
wasn’t  damaged  during  transport.  Ensure  that  the  power  supply 
specifications  on  the  mains  socket  correspond  with  the  information  on  the 
label attached to the back of the unit.  

-

 

The  electric  current  that  powers  the  unit  is  VERY  DANGEROUS.  Before 
connecting or disconnecting the power cable from the connecter on the unit, 
make sure it is plugged out from the mains socket.  

-

 

The power cable has an earthed plug for safety reasons.  

-

 

Only use with a mains socket suitable for use with earthed systems.  

-

 

The  equipment  should  only  be  connected  to  electrical  systems  that  fully 
comply with  
regulations.  

-

 

Check  the  integrity  and  the  existence  of  ground  conductor  if  extensions 
cables are used.  

-

 

Connect the equipment directly to the wall socket without using extensions. 
Failure  to  comply  with  these  warnings  may  result  in  dangerous  electrical 
discharges that could cause injury operators and compromise the functioning 
of the unit.  
 

USE 

-

 

The  laser  therapy  treatments  must  be  provided,  under  the  strict  control  of 
the  operator,  patients  conscious,  able  to  interact  with  the  operator  in 
response  to  stresses  transmitted  by  the  device;  in  case  of  default  to  the 
indications  given,  I.A.C.E.R.  srl  shall  not  be  consider  responsible  for  any 
accidents . 

-

 

The  use  of  the  controls  or  regulations  or  the  execution  of  different 
procedures from those specified in this user manual can cause the exposition 
to dangerous radiation. 

-

 

The  operator  has  the  responsibility  to  verify

 

that  the  issuing  head  remains 

well in contact  to the zone  of treatment,  to avoid the  emission to different 
zones from those to be treated.  

-

 

The laser radiation that outgoings from the device is dangerous: always use 
the appropriate glasses. Always avoid the exposition of the eyes to the direct 
or reflected laser beam. 

-

 

It  is  recommended  not  to  start  treatment  if  the  machine  is  not  in  perfect 
mechanical  condition  or  if  the  laser  does  not  present  characteristics  of 
approved for this purpose (see the specifications table).  

-

 

During  the  delivery  the  handpiece  must  be  positioned  in  contact  with  the 
part to be treated. After activating the handpiece through the pedal contact, 
avoid that it moves or is directed to different areas.  

-

 

THE PROBE MUST NEVER BE DIRECTED TO AREAS OF BODY SENSITIVE TO THE 
LASER RADIATION, FOR EXAMPLE THE EYES.  

-

 

ALWAYS AVOID THE EXPOSITION OF THE EYE TO THE DIRECT OR REFLECTED 
LASER BEAM.  

-

 

Do not leave the device switched on unattended, always switch off after use. 

-

 

Use  only  probes  accurately cleaned  and  disinfected  after each  treatment  in 
order to avoid environment and users contamination.  

 

The operator must pay attention to the necessity of a periodic maintenance 
(every  2  years)  of  the  probes/applicators.  IACER  srl  authorised  personnel 
should carry out such operations.  

 

It is absolutely forbidden in presence of anaesthetic inflammable substances 
and  in  full  oxygen  environment.  I.A.C.E.R.  will  be  not  responsible  if  these 
indications will be not complied.  

-

 

It  is  absolutely  forbidden  to  cover  the  ventilation slots:  such  an  action  may 
not allow the machine to work in safe conditions. In case of non-compliance 
with this indication, I.A.C.E.R.Srl will not be responsible for any accidents.  

-

 

It’s important to pay the attention of the operator to the necessity to verify 
the  correctness  of  the  electric  installation  of  device  before  activating  the 
supply switch. 

-

 

It is advisable to suspend the therapeutic treatment if it were to appear some 
disturbances during its emission.  

-

 

It’s strongly advised not to hold the device on in state of start without using 
the probe, it could overheat.  

 

Summary of Contents for LA500






















Reviews: