1.4 Action at an alarm occurrence
The alarm action (camera action at an alarm occurrence) will be performed when the following alarms occur.
1.4.1 Alarm type
•
VMD alarm:
When motion is detected in the set VMD area, the alarm action will be performed.
*VMD stands for “Video Motion Detection”.
•
SCD alarm:
This function triggers an alarm action when observed a change in the state of a subject such
as by covering the camera with a cloth, a cap or others, or by changing the camera direction largely.
•
Command alarm:
When a TCP alarm notification is received from the connected device via a network,
the alarm action will be performed.
•
Audio detection alarm:
When the configured audio detection level is exceeded, the alarm action will be
performed.
•
Alarm notification from the extension software:
In case that the extension software having an alarm
function is installed, an alarm action will be taken when an alarm is issued by the alarm function of the
extension software.
For further information about the extension software, refer to our technical information website <Control
No.: C0103>
1.4.2 Action at an alarm occurrence
Display the alarm occurrence indication button on the “Live” page
The alarm occurrence indication button will be displayed on the “Live” page at an alarm occurrence.
(
®
“1.1.2 About the “Live” page”)
Save images on the SD memory card
When an alarm occurs, images (JPEG/H.265/H.264) will be saved on the SD memory card. The settings to
save images on the SD memory card can be configured on the [SD memory card] tab (
®
settings relating to the SD memory card [SD memory card]”) of the “Basic” page and the [Alarm] tab of the
“Alarm” page. (
®
“3.8.2 Configure the settings relating to the camera action on alarm occurrence [Alarm]”)
Notify of alarm occurrences by E-mail
Alarm E-mail (alarm occurrence notification) can be sent at an alarm occurrence to the E-mail addresses
registered in advance. Up to 4 addresses can be registered as recipients of the alarm E-mail. An alarm image
(still picture) can be sent with the alarm E-mail as an attached file. The settings for alarm E-mail can be
configured in the “Alarm E-mail notification” section on the [Alarm] tab of the “Alarm” page (
®
the settings relating to the camera action on alarm occurrence [Alarm]”) and the [Advanced] tab of the
“Network” page (
®
“3.10.2.1 Configure the settings related to sending E-mails”).
Notify of alarm occurrences to the designated addresses (TCP alarm
notification)
This function is available only when our device, such as the network disk recorder, is connected to the system.
When “On” is selected for “TCP alarm notification”, the connected our device will be notified that the camera
is in the alarm state. The settings for TCP alarm notification can be configured in the “TCP alarm
Operating Instructions
25
1 Operations
