40
Set up recording/events [REC & event]
The "REC & event" page has 3 tabs; the [Recording setup] tab, the [Event setup] tab and the [Advanced setup] tab.
Recording setup tab [Recording setup]
Configure the settings relating to schedule recording. Set the day(s), time table(s), frame rate and image quality
for recording.
■
Schedules
Recording will be performed according to the
schedules set in advance. Select the day(s) of the
week and the time table(s).
[Days to record]
Select the day(s) of the week to record. Mark the
checkbox(es) of the day(s) of the week to record.
[Schedule to record]
6 time tables can be set up for "[Time table1]". The
time bar indicates 24 hours in steps of 15 minutes.
Click the desired position on the time bar to
designate the start and end time. When the time is
designated, the time bar turns red.
Note:
• At the default, schedule recording and event
recording have been set for 24 hours on Time
table1. To delete the designated start and end
time, right-click the timetable.
• The recording time table can be set by dragging the
start and end time on the time bar with the mouse.
• Be sure to set so that there is no overlap between
the 6 time tables. When attempting to set the
same time as already set on another time bar, the
time immediately before or after the overlapping
time will be set.
• Within the same time table, event recording has
priority over schedule recording.
[Schedule recording]
Mark the checkbox (es) if you want to carry out the
schedule recording based on the set time bar.
[Event recording]
Mark the checkbox (es) if you want to carry out event
recording based on the set time bar. The recorder
does not record the image even if the alarm occurs
during time in which the event recording is not set.
[e-Mail]
To send an alarm e-mail when an event occurs, mark
this item. The event recording must be checked to set
this item.
Refer to "Configure the settings relating to the mail
notification [e-Mail]" (
☞
the destination.
[Alarm notification]
Mark the checkbox of this item to automatically
transmit information on an event that occurs to a PC
using the TCP alarm notification protocol or HTTP.
The event recording must be checked to set this item.
Refer to "Configure the TCP alarm notification
settings [TCP alarm notification]" (
☞
"Configure HTTP alarm notification settings [HTTP
alarm]" (
☞
Page 60) for the setting of the address.
Important:
• If the setting in any one of Schedule 1 to 16 is to
notify an alarm notification, notification about
camera site alarm inputs (
☞
made even for cameras to which have been
allocated the schedules in which alarm notification
has not been set.
[Advanced >] button
The "Advanced schedule setup" page will be
displayed. In addition to 6 schedule recordings, 6
event recordings can be set up. The schedule
settings can be set up to 16 patterns. (
☞
[Setup via recorder's main monitor]
