ISH & ISHV & ISHVS CONNECTOR Instruction Manual
Document No.
HDM-0002
20
/
29
Confidential C
6-2. Retainer
①
Place the releasing jig into the releasing apertures situated on the side of the housing (Pos.1side),
and push out the retainer (see Fig.37).
Retainer releasing JIG: Part No. AP0004-02-001
、
AP0031-02-001
Refer to Table 6 for the Part No. that use retainer releasing jig.
Notes
①
Do not use the releasing jig for any other part of the housing other than the releasing apertures. Doing so may cause damage or
reduced performance.
②
Check for any deformation or damage on both of the retainer and the female housing after releasing the retainer, before
continuing any operation.
③
If there is any damage or deformation, do not use it.
Replace the item with a new one.
④
Only use the retainer releasing jig specified.
⑤
Care must be taken not to damage edge of the jig (e.g. from dropping, etc.)
Fig 37. How to release the retainer
Direction of
release
Retainer releasing jig
Releasing jig aperture
