CABLINE-VS II PLUG Assembly Manual
Document No.
ASM-17005
10
/
16
Confidential C
5-2. Cautions in treating SHELL A
SHELL A is delivered in the reel with a carrier. The following is the method to cut SHELL A from Carrier.
①
Cut carrier on the cut line of the left below picture (green line) by a scissors for metal.
②
Hold the center of Plug shell-A and cut it off from Notch by
±
45 deg of reciprocating work.
When it does not be cut, try again this reciprocating work.
After separated, check there is no burr around the cut part.
（
Photo.7
）
Plug SHELL A Detail of Notch
Caution: By pulling like the photo below to cut off by force (Red arrow direction), burrs and transformation can be caused.
Carrier
Notch
Photo.4 Before cut
Photo.5 After cut
Cut Line
Photo.6 Cut condition
Photo.7 After cut
Without burrs
45
°
45
°
Photo.8 Bottom side view
Photo.9 Upper side view
Photo.10 Cut by force (Bad example)
