I+ME ACTIA I+ME ACTIA NetPorty II, User Manual

Page: 20 / 50

Installation
Overview
Version 1.03
2-2
2.1 Overview
This chapter gives detailed information about installing
the
NetPorty II hardware and about the necessary
software drivers which make NetPorty II access
possible.
The NetPorty II is delivered with access driver and
applications for Windows 95 and Windows NT. To get
your
NetPorty II operational follow the installation guide
lines.
2.2 Installing the Hardware
To install the hardware you should connect the
NetPorty II to the serial or to the parallel port of your PC.
If the NetPorty II operates at the serial port of the PC
the adapter cable will be used to get the right signals.
Plug in the 25 pin D-Sub connector of the adapter cable
to the
NetPorty II and the 9 pin D-Sub connector to the
serial interface of the PC.
The NetPorty II can operate at the parallel port which
must be configured as EPP
1
(V1.7 or V1.9) mode.
ECP
2
.mode is not supported.
Make sure that the right interrupts are used in the
systems configuration and the BIOS settings.
1
EPP: Enhanced Parallel Port
2
ECP: Extended Capabilities Port