5
PROGRAMMING
PROGRAMMING
This section will discuss setting up the coin selectors. In
order for the coin selectors to work properly, a “sample” of
the coin or token that will be used for playing the game,
must be placed in the optical comparator of each coin
selector.
To accomplish this task, please perform the following:
1. Remove the rounded cover on the front of the game.
To remove the cover, open the game’s coin door.
This is the lower door located in the center of the
lower front of the cabinet.
2. Reach up underneath the cover and release the 2
latches that secure the cover to the game. (see photo
below) Remove the cover.
3. Determine the type of coin or token that will be used
to play the game.
4. Lift up the coin sensor holder.
5. Insert your coin or token of choice.
6. Release the coin sensor holder. Be sure that the coin
or token is properly seated.
7. Test the coin selector before replacing the front cover.
If the coin selector does not recognize the coin, or
allows coins other than the “compared” coin, a coin
sensitivity adjustment can be made.
8. Locate the coin sensitively adjustment dial on the rear
of the unit. To increase sensitivity, turn the dial
counter-clockwise. To decrease sensitivity, turn the
dial clock-wise. (see photo below)
COIN SENSITIVITY
ADJUSTMENT DIAL
