4
PROGRAMMING
PROGRAMMING
This section will discuss subjects such as setting up cred-
its, time per game, etc. The section below will show how
to enter into the programming mode and how to adjust
many of the game’s operating parameters.
ENTERING SET-UP MODE
You must enter set-up mode to adjust all of the game fea-
tures. This can be accomplished in the following manner:
1. Open the game’s coin door. This is the lower door
located in the center of the lower front of the cabinet.
2. Locate the Programming / Advance & Select buttons.
They are located on the inside panel just above the
Cash Box. (See photo below)
3. To enter programming, press the Program button
once. Each programming mode is identified by the
“LED lit” (mode 1, 1st LED lit, mode 2, 2nd LED lit;
etc.). To exit programming, press the Program button
once.
CHANGING GAME SETTINGS
When you press the Program button, you will be in the
programming mode.
1. Each push of the Select button will advance you
through the programming modes.
2. Push the Select button to keep you in that mode.
3. Pushing the Advance button will advance you through
the settings for the mode you are in.
4. To exit and save your new settings, press the Pro-
gram button once. You will now be in the normal
game play mode.
MODE #1
VOLUME
This mode adjusts the volume from 0 to 5, 0 being the
highest level and 5 being the lowest level. The default
setting for this mode is 3.
NOTE: If power is removed from the PC Board, all other
custom game settings will have to be re-entered.
MODE #2
JACKPOT MULTIPLIER
This mode is for the jackpot multiplier from 1 to 20, and
multiplies by 25. (e.g. setting this mode to 8 gives a jack-
pot of 200) The default setting for this mode is 20.
MODE #3
NUMBER OF LOCKS
This mode is used to set the number of locks needed to
get the jackpot. The setting range is from 1 to 4, where 4
is 4 locks needed and 1 is 1 lock needed. The default set-
ting for this mode is 1.
MODE #4
GAME DIFFICULTY
This mode is for the ability window and the setting range
is from 0 to 14, 0 being the easiest and 14 being the hard-
est. Suggested setting for this mode is 10. The default
setting for this mode is 13.
MODE #5
WHEEL JACKPOT VALUES
This mode is used to set the values for the wheel ticket
values. To enter this mode, press the Select button until
all 4 LEDs light up. Press the Select button to advance
through the wedges on the wheel. To change any of
these values, press the Advance button. The “BONUS”
value setting range is from 0 to 50, in increments of 5.
The setting range for the remaining ring wheel values is
from 0 to 9 in increments of 1.
IF YOU HAVE ANY QUESTIONS REGARDING SET-UP
AFTER READING THIS SECTION, CALL OUR SERVICE
DEPARTMENT BEFORE PROCEEDING AT:
I.C.E. SERVICE DEPARTMENT
716-759-0360
NORMAL BUSINESS HOURS ARE:
MONDAY – FRIDAY, 9:00 AM TO 6:00 PM EST
PROGRAM
BUTTON
ADVANCE
BUTTON
SELECT
BUTTON
