![background image](http://html1.mh-extra.com/html/hyundai/wfc-1047-d10/wfc-1047-d10_instruction-manual_2197661009.webp)
ENG
ENG - 9
CHAPTER 3: SETTING UP
ELECTRICAL CONNECTION/WATER INLET CONNECTION
ELECTRICAL CONNECTION
•
Your washing machine is set to 220-240V and 50Hz.
• Mains cord of your washing machine is equipped with a specific grounded plug. This plug
should always be inserted to a grounded receptacle of 10 amperes. Fuse current value
of the power line connected to this plug should also be 10 amperes. If you don’t have such
a receptacle and fuse confirming with this, please have it done by a qualified electrician.
•
We do not take the responsibility of the damages that occur due to ungrounded usage.
•
Operating your machine under low voltage will cause the life cycle of your machine to be
reduced and its performance to be restricted.
WATER INLET CONNECTION
•
Your machine may have either a single inlet (cold) or double water inlets (cold/hot) based on
its specifications. White-capped hose should be connected to cold water inlet and red-capped
hose to hot water inlet (applicable for machines with double water inlets).
•
To eliminate water leakages in points of contact, 1 or 2 nuts are provided in the hose
package (applicable for machines with double water inlets). Fit these nuts to the ends of new
water inlet hoses on the side of faucet.
•
Connect the white-elbow end of the water inlet hoses to the whitefiltered water inlet valve on
the rear side of the machine and the red-elbow end to red-filtered one (applicable
for machines with double water inlets). Tighten plastic parts of the junctions using your hand.
In uncertain conditions, have the connection works be done by a qualified plumber.
•
Flow of water with pressure of 0.1-1 Mpa will allow your machine to operate more efficiently
(0.1 Mpa pressure means that more than 8 litres of water will flow through a fully-tapped
faucet per one minute).
•
Ensure that points of contact do not leak by tapping the faucet completely after carrying
making the connections.
•
Ensure that new water inlet hoses are not folded, broken, crushed or their dimensions are not
altered.
•
Mount new water inlet hoses to a ¾ “, threaded faucet.
•
If your machine has double hot water inlets, the temperature of hot water inlet should
be maximum 70°C.