Tightening torque :
7.8 ~ 11.7 N.m ( 0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 Ib-ft)
Plug or cap the lines immediately after disconnecting them to avoid moisture and dust contamination.
5. Disconnect the inlet (A) and outlet (B) heater hoses from the heater unit and then remove the cover (C).
Engine coolant will run out when the hoses are disconnected; drain it into a clean drip pan. Be sure not to let
coolant spill on electrical parts or painted surfaces. If any coolant spills, rinse it off immediately.
6. Remove the center console.
(Refer to BD group - "Center Console")
7. Remove the steering handle and column.
(Refer to ST group - "Steering Column")
8. Remove the cowl top cover.
(Refer to BD group - "Cowl Top Cover")
9. Remove the photo sensor.
(Refer to HA group - "Photo Senosr")
10. Loosen the cowl cross member mounting bolts (A).
https://www.hyundaitechinfo.com/viewer/toc_print.asp?vehicletype=Pas...
33 of 57
3/12/2012 8:27 PM
