Hyundai TR1118, User Manual

Page: 11 / 24

ENG - 11
DESCRIPTION
1. Dial Scale
2. FM STEREO LED Indicator
3. TELESCOPIC Antenna
4. HEADPHONE Socket
5. VOLUME Control
6. BUILT-IN Microphone
7. FUNCTION Selector
8. STEREO / MONO Mode Selector
9. BAND Selector
10. TUNING Control
11. CASSETTE Compartment
12. PAUSE Button
13. STOP / EJECT Button
14. FAST FORWARD Button
15. REWIND Button
16. PLAY Button
17. RECORD Button
18. Handle
POWER SUPPLY
1. Plug the supplied AC power cord into the AC POWER socket on the back of this. Connect
the AC Power Cod to your AC household mains outlet and switch on the mains supply. Make
sure the voltage is compatible.
2. Always remember to disconnect the power cord from the mains supply before disconnecting
the lead from the unit.
3. Disconnect the power cord from the mains when not in use.
BATTERY OPERATION
1. Open the battery compartment and insert 4 x UM-1 batteries (D cell or equivalent) following
the polarity diagram shown in the battery compartment of the unit.
2. Batteries should be removed from the compartment if the unit is not to be used for some time.
3. Flat batteries should be removed from the unit to avoid leakage.
4. Remove mains lead from AC Socket when unit is on battery supply. Battery power is auto-
matically disconnected when the AC lead is connected to the AC Socket.
RADIO OPERATION
1. Set the FUNCTION Selector (7) to the “RADIO” position.
2. Select the desired frequency band with the BAND Selector (9).
3. Tune to the desired radio station by tuning the TUNING Control (10).
4. Adjust the VOLUME (5) control to the preferred level.
5. Set the FUNCTION Selector (7) to the “TAPE” position to turn off the radio.
6. When an FM signal is tuned in, the FM STEREO Indicator (2) will light up.
ANTENNA For FM reception there is a built-in TELESCOPIC Antenna (3) at the rear of the
unit. Extend the antenna and move it around to obtain the best reception.
For AM reception the signals are picked up through a built-in ferrite antenna.
You may have to orient the unit to obtain the best reception.
INSERTION AND REMOVAL OF CASSETTES
1. Press the STOP / EJECT key to open the cassette door.
2. Slip your cassette tape into the door, with the exposed section uppermost and the playback
side facing you. Close the cassette door securely.
3. When finished, press STOP / EJECT key to open the cassette door, and retrieve your
cassette tape.
ENG