EN
EN - 55
will automatically update the system clock to the received RDS clock time. The system clock is
now adjusted.
FM & FM-STEREO RECEPTION (BY REMOTE HANDSET)
●
Press the “ FM-st/mono ” button at remote handset repeatedly, the FM programs are
receiving in mono and stereo mode repeatedly. In particular when stereo signals are weak. It
is preferable to receive the program in mono.
●
If stereo signal is being received, the “ST ” indicator “
” will appear on LCD (2) to show
FM stereo program is now receiving.
Hints for best reception:
-
●
FM : The receiver has a build-in FM wire antenna (36) hanging at the rear cabinet. This wire
should be totally unraveled and extended for the best reception.
PHONO
noted:
- Remove the stylus protector.
- Be sure that the tone arm is being detached from the tone arm
rest before operating and re-secured again afterwards.
1. Select to “ Phono ” mode from function selector (10)
2. Set the speed selector (32) to the proper position depending
on the type of record to be played.
3. place the record on the platter (use the spindle adaptor (31) if
required).
4. Lift the tone arm from the rest (34) and slowly move it to the
record side. The platter will start to rotate.
5. Place the tone arm to the desired position of the record.
6. Adjust the Volume up/down button (3) to the desired level.
7. At the end of record, the platter will automatically stop rotating. Lift
the tone arm from the record and return it to the rest position (34).
8. To stop manually, lift up the tone arm from the record and return it
to the rest (34).
Remark
: As some kind of record the auto-stop area was out of the unit setting, so it will stop
before the last track
fi
nish. In this case, select the auto-stop switch (33) to “ off “ position, then it
will run to the end of the record but will not stop automatically (turn off the unit by power button
or switch back the auto-stop switch (33) to “ on “ position to stop the platter rotate). Then put
back the tone arm to the rest position (33).
PLAYING COMPACT DISC
●
Getting start
1. Select “ CD ” mode from Function selector (10)
2. Press “Open/close” button (25) to open the CD door.
3. Place a CD with the printed side facing up inside the tray.
4. Press the “
“ button (23) to turning the CD tray, and loading out the other disc
compartment.
5. Press the “Open/close” button (25) to close the cd door after placing all discs inside.
6. CD search is performing, the LCD display (2) will show the total number of disc, number of
tracks & playing time of disc.
Noted
: CD searching will be performed every time when switching to CD mode or closing the
CD door. All CD functions will be response only after the CD reading is completed.
