EN - 31
EN
PREPARATION FOR USE
• Carefully remove the unit from the display carton and remove all
packing material from the unit.
• Unwind the AC power cord and extend it to its full length.
• Unwind the FM Antenna wire and extend it to its full length.
• Place the unit on a stable, level surface, convenient to an AC outlet
out of a strong magnetic field.
• Raise the lid to expose the phonograph. The phonograph has been
secured for shipment with a transit screw. Use a coin or screwdriver
to turn the transit screw clockwise. This will allow the turntable to
„float“..
• Remove the opaque white plastic stylus cover from the phonograph
stylus by sliding it in the direction of the arrow.
• During this operation pay attention to the stylus, because the stylus
damage is not covered by guarantee.
• Remove the twist-tie that was used to secure the tone arm during
shipment.
• Release the tone arm lock lever.
• Connect the plug to your AC 230V,50Hz outlet.
POWER SOURCE
This product is designed to operate on normal 220 V 50 Hz AC only. Attempting to operate this
system from any other power source may cause damage to the system, and such damage is
not covered by your warranty.
IMPORTANT: Raising And Lowering The Phonograph Lid
To open the lid, raise it as far as it will go until the lid support bracket ‚locks‘ in the open position.
To close the lid, lift it upward slightly until the lid support bracket ‚unlocks‘, and then gently lower
the lid.
TO AVOID DAMAGING THE CABINET OR THE LID, NEVER FORCE THE LID CLOSED.
ALWAYS RAISE THE LID TO RELEASE THE LID SUPPORT BRACKET.
Summary of Contents for RTC 1028 RIP
