Genuine Accessories
Wire Cutters
Caution : Do not pinch the factory harness & Remote Start Harness
between the fuse box and steel tubing.
N
O
T
E
16
17
A. Connect the 20-Pin Connector (black) to the Control Module.
B. Connect the 4-Pin Connector (black) to the Control Module.
C. Verify the following:
- Control Module is attached to Antenna Bracket.
- Both black 6-Pin connectors are attached to Antenna and Control Module.
D. Connect 9-pin connector (White connector) to the Relay Module.
N
O
T
E
A. Using one (1) Wire Tie, secure the Relay Module to Remote Start
Harness as shown.
B. Trim excess Wire Tie material.
Ensure that each Connector is fully seated in the Control Module, in the
Antenna and in the Relay.
Ratchet, Torque Wrench, Extension and 10mm Socket
15
Ratchet, Torque Wrench, Extension and 12mm Socket
14
N
O
T
E
A. Remove the 12mm Dash Bolt from the bracket located by the Fuse Box,
as shown.
B. Route the Ground Wire across the front of the Fuse Box, as shown
above, then up and over to the 12mm Bolt hole.
C. Insert the 12mm Bolt into the Ground Wire Ring Terminal, then reinstall Bolt.
D. Torque the 12mm Bolt to:
16.7 ~ 21.6 N.m (1.7 ~ 2.2 kgf.m, 12.3 ~ 15.9 lb-ft)
A. Route the Remote Start Harness (CAN T-Taps) towards the left side of
the fuse box.
B. Reinstall the fuse box with the two (2) 10mm nuts.
C. Torque the two (2) 10mm nuts to:
10.0 N.m (1.0 kgf.m, 90 lb-in)
N
O
T
E
12mm
Dash
Bolt
10mm Nuts
Black 6-Pin
Connector
Black 4-Pin
Connector
Black 20-Pin
Connector
Antenna
Control Module
Antenna
Bracket
Relay
White 9-Pin
Connector
Wire Tie
Revision Date
06/05/2020
Page 9 of 13
