Genuine Accessories
N
O
T
E
A. Position the Control Module Assembly (Control A
Antenna H Antenna Bracket) as shown.
B. Using two (2) Wire Ties, secure the Control Module Assembly to Factory
Harness as shown.
C. Secure the Remote Start Harness (CAN T-Taps) to the Factory Harness
as shown using one (1) Wire Tie.
D. Trim excess Wire Tie material.
20
Wire Cutters
18
19
Ensure the Control Module Assembly is fully seated on the Factory
Harness.
N
O
T
E
A. Clean the left top surface of the Radiator Cover.
- Ensure the surface is completely dry.
B. Remove the Adhesive Liner from the Warning Label, then adhere
the label to the Radiator Cover as shown.
N
O
T
E
A. Reconnect the Negative (-) Battery Cable. Torque to:
5.0~ 6.0 N.m ( 0.5~0.6 kgf.m,45~ 52 lb-in)
B. Reinstall the vehicle's Negative (-) Battery Cover, if applicable.
C. Temporarily re-install the Lower Dash Panel (with the Hood Release Lever)
D. Reinstall the weatherstrip at dash area to allow Driver's Door to
close properly.
E. Close the Hood, Tailgate and all Doors.
F. Test the LOCK / UNLOCK function using Factory Key Fob.
Ensure the surface is completely dry before installing the Warning
Label.
Ensure the label is aligned straight with the edge of the Radiator Cover
NOTE: If vehicle is not responding, carefully re-check all wiring
connections. If the vehicle is still not responding, follow the
Troubleshooting at the end of the instructions.
21
Ratchet, 10mm Socket, Extension and Torque Wrench
A. Using one (1) Wire Tie, secure the Remote Start Harness to Vehicle
Harnesses as shown.
B. Trim excess Wire Tie material.
N
O
T
E
Wire Cutters
Wire Tie Mounting Holes
Feed wire tie through each
hole on Control Module and
tie to vehicle harness.
Wire Ties
Control Module
Assembly
Wire Tie
Wire Tie
Vehicle
Harness
Warning Label
Negative Battery
Cable
Fuse Box
Relay Module
Revision Date
06/05/2020
Page 10 of 13
