Hyundai JE 337, Instruction Manual

Page: 28 / 48

28
/ 41
PREPARATION AND USE
Remove all packaging material and remove the appliance with accessories. Remove all adhesive
foils, stickers or paper from the appliance. Wash all parts which will come in touch with food in hot
water with soap, rinse them thoroughly with clean water and wipe dry
or let dry before first use.
ASSEMBLy (pic. 2)
Insert the pulp container F into the holder.
Slide the container B into the propulsion unit A all the way.
Put the sieve C onto the propulsion shaft A3 a secure it with slight pressure.
Put the lid
D
onto the container
B
and secure it by snapping the closure
A4
(at the same time,
the safety lock is unlocked). Pay special attention to this operation. The lid is now secured in the
proper position and drive unit A can work.
Proceed reversely when removing the individual parts.
Note: If the has been placed and secured incorrectly, the appliance will not turn on.
Food preparation
• The appliance is intended for processing almost all kinds of fruit and vegetables.
• Currant, bananas, avocado, figs, mango etc. are not suitable for processing in the juicer.
• Such fruits may be processed with fruit processing machine, mixer and flour-kneading machine.
• Always use fresh, ripe fruits and vegetables which will give you more juice.
• Remove the stems and haulms.
• Wash the fruit or vegetables thoroughly.
• Cut bigger foods into smaller pieces.
• Remove pits (e.g. with plums, apricots, cherries, etc.)
• Remove thick skin (e.g. with melons, pineapples, cucumbers, potatoes, beet, celery, etc.)
• Peel citrus fruits and remove white pulp and seeds; otherwise the juice could turn bitter.
• Foods with thin skin do not need to be peeled (e.g. apples, pears, carrots, radish, parsley, etc.).
Use of the appliance
Place the assembled juicer on a firm, flat and dry surface (see par. I. SAFETy PRECAUTIONS ).
Openings in the appliance ensure the flow of air during ventilation and must not be covered or
blocked in any way. The feet of the appliance must also not be removed. Make sure that the po-
wer supply cord is not damaged and that it does not lead through any sharp or hot surfaces. The
socket must be easily accessible so that it would be possible to unplug the appliance immediately
in case of danger. Plug the fork of the supply cord A5 into the el. outlet.
Place the container G without the lid G1 or another suitable container for juice.
Turn the appliance on by turning the switch ON and speed-selector
A1
to desired position
according to the food processed.
-
When processing soft/juicy food (e.g. apples, citrus fruit, tomatoes, etc.), turn the selector to
position 1 (low speed).
-
When processing food with lower juice ration (e.g. carrots, parsley, etc.), choose a higher
speed.
-
When processing hard food (e.g. celery), turn the regulator to position 5 (high speed).
Feed the prepared food into the feeding opening D1 a push them slightly with the stamper E . Do
not push hard on the stamper, it could affect quality of the juice or even cause the appliance to
stop. Having finished using the appliance, turn it off, wait till the rotating sieve stops completely
and unplug the appliance from the outlet by pulling out the fork of the supply cord from the socket.
Before pouring the juice, put the lid G1 on the container G which will catch the foam.