![background image](http://html1.mh-extra.com/html/hyundai/hyuap610/hyuap610_instruction-manual_2195011024.webp)
ENG - 24
BEFORE USE
Applicable areas
• The unit is applicable for any room with a size
of max. 40 square meters. It can be used in the
bedroom, sitting room, etc.
• If the unit is to be used in a smaller room, you
may prefer to set the unit under quiet or low
mode.
Air ventilation
• After plugging in, the unit sensor will retain a
memory of the existing indoor air condition (The
existing indoor air condition will be input as “Clean Air”).
• Once started, the clean indicator will blink 3 minutes, showing it memorizes the existing fresh
air condition. After 3 minutes, the clean indicator will die off, and air monitoring indicator will light
to show the cleanliness of the air (in the range CLEAN - MEDIUM - UNCLEAN). All memorized
content will be erased when the unit is unplugged.
• If the unit starts running after 5 minutes of plugging in, the air monitoring indicator will not blink.
(Once the unit start running, the air monitoring indicator will light to show the cleanliness of the
air.)
• When smoke, make up or any spray that contains alcohol is present, please ventilate and
freshen the air before closing window.
• Sometimes the sensor is not as sensitive when purchased or after being unplugged for over
a week. Its sensitivity will recover after one to two days of operation.
INSTRUCTIONS FOR USE
Place the device at least 30cm against the wall and where children cannot reach within a short
range of distance.
H
ow to Start
• Plug into a proper socket. Press the power button, the device starts operation under “
Automatic
Operation
” mode; press the power button again, the device starts operation under “
sleep
operation
” mode; press the power button third time, the device will stop working.
• In the beginning operation of the machine, the clean indicator will blink 3 minutes, and its
sensor is preheating at the same time.
Manual Operation
• Under “
Automatic Operation
” mode, every click the “
Air Volume
” button, circular air
flow modes will be according to “quiet – low – high – quiet” to cycle, the LED will show the
following sequence of modes:
Sleep Operation
• Press “
ON/OFF
” button to start sleep operation mode.
• The LED of sleep is light.
• All lights brightness is reduced by half, the machine will run under “
quiet
” operation mode.