Hyundai HYUAP580, Instruction Manual, Page: 26 / 52

ENG - 26
-
Please beware not to damage any wiring when cleaning the dust collector. In case if any
electrical discharge wire is broken, the device will lose part of or all of its dust collecting function
-
Any broken wire should be thrown away instead of being left inside the unit. Otherwise, short-
circuit or high-voltage spark would be resulted. Also, the circuit control of the device would be
affected.
-
Please contact the distributor for additional electrical discharge wire
-
Please do not clean using acidic or alkaline detergent that can create rust on the surface
of device
Thorough clean and dry
-
After cleaning, please completely dry the unit before use. Otherwise, it could cause electrical
shock or malfunction
-
If the front cover of the electrostatic dust collector is not properly installed, no electricity will be
connected
-
Please make sure the plastic wrap for the electrical discharge wire is located at its proper
position.
Cleaning and Replacing filters
• The filter will collect large amount of the dust , you may use a soft brush to clean it.Please
replace with new filters if using for more than one year or the filter is heavily polluted.
Replacing UV Lamp
• Each 12 months, you may need to change UV lamp.Turn off the unit, unplug the plug from the
socket and make sure the item is off power.Gently take out the UV lamp form the UV lamp
holder.
• Put new UV lamp into the UV lamp holder and make sure it is in its proper position.
Reinstating
1) After cleaning and drying every part, then install the unit. Put every part back together with the
same steps but with opposite sequence.
2) There’s metal electrode at the bottom of the electrostatic dust collect, please make sure to
install at its proper position. Otherwise, the device cannot be energized.
3) There’s safeguard protective switch designed for this device, please make sure to install front
cover properly. Otherwise, the device cannot be energized.
FREqUENTLy ASKED qUESTIONS
Filter
Why is it so hard for the filter to get rid of dust and odor?
• The filter has been saturated with a serious amount of dust. Please replace with new filter.
Electrostatic Dust Collection
Why is it so difficult to collect dust and eliminate odor?
• The electrical discharge wires or the plasma dust collector already gets too dirty. Please clean
and maintain this collector.
• Have any of the electrostatic collector wires been unplugged or broken? Please contact your
service centre.