![background image](http://html.mh-extra.com/html/hyundai/hysg150/hysg150_user-manual_2196457023.webp)
PROBLEM
POSSIBLE SOLUTION/S
Belt coming OFF
Pulleys not aligned
Insufficient belt tension
Belt engages late
Tighten belt
Reduce cutting depth
Belt does not stay tight
after adjustment
Check for damage on axle, pulley or key. Make sure that the set
screws are properly tightened
Replace damaged parts
The cutting wheel does
not rotate
Insufficient engine speed to operate centrifugal clutch
Insufficient belt tension
Clutch is worn, replace clutch shoes, springs and/or clutch bearings
The cutting wheel
continues to rotate
Check that the throttle is disconnected
Check for damage to throttle cable
Check throttle cable is properly mounted onto the throttle valve
The engine speed is NOT under 1000 rpm, which is required to
disengage the centrifugal clutch.
Inspect springs on the clutch shoes, if tension on clutch shoes in not
enough to pull shoes back, replace spring and clutch shoes
The parking brake is
slipping
Adjust the brake tension in the manner described in the user manual
Check for damage on the brake rod or lever
Check for wear on the brake pads. Replace as necessary
10. STORAGE & TRANSPORTATION
10.1.
Winter storage.
NEVER store an engine with fuel in the tank indoors or in poorly ventilated spaces where fuel
vapour can come in contact with open flame, sparks or a pilot light such as in a boiler, hot water
tank, clothing drier, etc. handle the fuel with caution. It is very flammable and careless use can
cause serious damage to person and property. Drain the fuel into an approved container
outdoors and far away from open flame. NEVER use petrol for cleaning, use a de-greaser and
warm water instead.
10.1.1.
At the end of the season, the machine should be readied for storage (or if it will
not be in use for longer than 30 days). Fuel allowed to stand for long periods of
time (30 days or more) can leave sticky residues that can cause the carburetor and
engine to clog up and reduce their function.
10.1.2.
Fuel stabilizers are an acceptable option as to reduce sticky residues during
storage. Add stabilizer to the fuel in the tank or in the storage container. Always
use the mixing ratios specified by the manufacturer of the stabilizer. Run the
engine for at least 10 minutes after adding the stabilizer so that it reaches the
carburetor. DO NOT empty the fuel tank and the carburetor if you have added
stabilizer.
10.2.
Storage.
10.2.1.
Before storing the machine you MUST allow the engine to fully cool down. NEVER
store the machine near any naked flame or any other sources of ignition.
Page 23
Summary of Contents for HYSG150
Page 1: ...STUMP GRINDER Model HYSG150 User Manual ...
Page 2: ...Page 2 ...
Page 27: ...Page 27 ...